North Corridor · Broomfield, CO
Viking Appliance Repair in Broomfield
Anthem is the large master-planned community in Broomfield, sold in phases across some eighteen years and now built out, and the newer neighbourhoods around it were put together the same way. Houses that look alike from the kerb can hold equipment bought years apart. The room those appliances stand in was drawn once, at the start, around whatever the catalogue offered in that season.
Housing stock
Option-list kitchen
A kitchen whose appliances came from an upgrade menu attached to the purchase contract. The layout, the services and the openings were drawn before that choice was made, so the equipment had to suit the plan instead of the plan being altered to suit the equipment.
A hood narrower than the surface under it
The hood and the range are two separate lines on the same order, and nothing on that order compares them. A hood picked to sit flush between two wall cabinets can end up narrower than the cooking surface below, which leaves the outer burners working beyond anything it can collect. That is a specification decision rather than a fault, and servicing the blower will not change it. Compare the two widths on the order, and read the mounting height the hood's own installation instructions call for before the cabinet above it is built.
Custom houses ask different questions from plan houses
These communities are not one product. Alongside the plan-built streets sit enclaves of custom houses whose joinery was made after the appliances were chosen, and the difference shows the first time anything has to come out. In a custom kitchen the panels, the filler and the toe kick were cut for that unit and go back the way they came off. In a plan-built one the opening is generic and the trim around it is doing work. Mention which of the two you have when the visit is booked.
Replacing an appliance into a finished room
When an option-list appliance is replaced ten years on, the room is no longer negotiable: the stone is cut, the tiling stops where it stops, and the cabinet on either side has a finished end. Dimensions shift between generations of the same equipment, so a replacement that matches on paper can miss by the depth of a trim piece. Take the opening as it stands today, then check it against the current installation instructions for the exact model before anything is ordered.
Spec check
Confirm each of these before anything is cut, ordered or delivered.
- The model and serial number read from the appliance's own plate, not from the handover folder
- The width of the hood against the width of the cooking surface it sits over
- The opening as it is today: width, height under the counter, depth to the finished wall
- Whether the joinery around the unit was cut for that appliance or is generic trim
Questions on site? Viking Appliance Repair Denver, (720) 770-4189.
Reviews
From Broomfield kitchens
4.9/ 5520 reviews
Two back burners had stopped sparking entirely. Not the module another company blamed — the harness plug behind the manifold had backed out and corroded. He reseated and sealed it, then tested every burner twice.
Marla D.Cherry Creek
Display went dark halfway through a roast and the oven quit with it. A cooked solder joint on the power board, which he showed me under a light. Board swapped, and it has behaved since.
Katya P.Capitol Hill
Every load stretched past three hours before it finished. The thermistor was reading low, so the machine kept waiting on water that was already hot. New sensor and cycles run normally again.
Pearl S.Highland
Viking calls in Cherry Creek, Washington Park, Highland, Capitol Hill.
Book a visit
A question now is cheaper than a change order later
$89 buys the visit and a complete diagnosis, and it comes straight off the bill once you approve a repair. Nothing gets ordered and nothing gets fitted until the number is in front of you.